Installing the Pro Series is quick and easy with our 3-minute installation guide
-
Remove your existing showerhead from the shower arm.
-
Clean the shower arm threads to remove any limescale or buildup. Wrap plumber’s tape around the threads clockwise 2–3 times.
-
Screw the Pro Series onto the shower arm. Hand-tighten, then use the included wrench to snug it slightly—do not overtighten.
-
Apply plumber’s tape clockwise 2–3 times to the bottom threads of the Pro Series.
-
Screw your existing showerhead onto the Pro Series.
-
Turn on the water and flush for 30 seconds before use.
Important tips to prevent leaks or clogs
Most leaks or flow issues are caused by insufficient plumber’s tape, cross-threading, or overtightening. Make sure plumber’s tape is applied evenly in a clockwise direction and that all connections are straight and snug—not forced. If you notice dripping, low pressure, or clogging, these can usually be resolved with quick adjustments.
See our guides on fixing leaks, and reduced water pressure for more information.